Gasket Inspection - Waring Commercial WCS220 Série Mode D'emploi

WHEEL CLEANING
After many sharpening
operations, clean the
sharpening stones (10)
of sharpening residue
with a metallic brush.
Wipe sharpening wheels with alcohol after cleaning.
Any other servicing should be performed by an authorized service
representative.

GASKET INSPECTION

The recommended interval between
inspections shall not exceed six months for
components that are detached for cleaning
and sanitizing and twelve months for all others.
The inspections must be made by the
manufacturer or its authorized service agent.
WARNING
The slicer must be removed from service until repaired by the
manufacturer or its Waring authorized service agent if any gasket or
seal is found to be damaged, or missing.
Inspections instructions shall include: Location of all gaskets and
seals located in food and splash zones.
REMOVABLE
ACCESSORY PARTS
NOTE: Contact your nearest
authorized service center for blade
replacement
Transmission
The transmission is made by a
multigrip belt. It is not necessary to
regulate.
– Do not let dirt or oil come into
contact with the transmission, as
this will affect the performance of
the slicer.
– In that case, it must be replaced,
taking care of de-greasing both the motor pin and the pulley.
WCS300
15
WCS220/250
Gasket between
slice thickness
control
Protection on
the switch