Waring Commercial WCS220 Série Mode D'emploi page 14

Clean the blade (3) on both faces
as indicated in the drawings.
WARNING: The slicer blade is very sharp. Exercise extreme caution
when working near the blade.
It is recommended to use the proper anti-cut gloves to avoid
danger of cutting.
– Disassemble the blade cover (4).
– Loosen the blade cover release knob (9), unthread it and remove
the blade cover.
IMPORTANT! A micro switch interrupts electrical current supply
whenever the blade cover release knob (9) is removed.
Use a soft cloth moistened with a neutral detergent and wipe blade
from the center out.
Rinse with hot water and dry.
An important step to kill bacteria is to allow the parts to air-dry
before using.
DO NOT exceed chemical manufacturer's recommended
concentrations for detergent or sanitizer. Do not exceed
200 parts per million concentration of available chlorine
(1 tablespoon of 5.25% sodium hypochlorite bleach with
1 gallon of water). The effect of the sanitizing solution varies
with its temperature and concentration.
NOTE: Failure to follow use, care and maintenance instructions
may void your warranty.
Use ONLY products formulated to be safe on stainless steel
or aluminum.
14