Instructions For Assembly Of The Sliding Plexiglas Doors On The Back - Arneg Aspen 2 Mode D'emploi

2. Instructions for assembly of the sliding plexiglas doors on the back

Attention!: Disconnect power to the cabinet before performing any operation.
Equipment necessary for assembly:
To assemble the superstructure for the Aspen cabinet, proceed as follows
15 A - Insert the upper support profile for the
sliding doors.
B - Fasten the upper support profile for the
sliding doors
16 Apply the fastening dowels on the lower
support profile for the sliding doors.
17 Fasten the lower support profile for the sliding
doors onto the edge of the counter top.
18 Mount the counter top complete with the lower
support profile for the sliding doors.
Insert the sliding doors on the back
05060096 02 03/08/2015
Screwdriver – Allen wrenches 2/3/4.
:
Aspen 2
English
39