Instructions For Assembly Of The Aspen Vca Superstructure - Arneg Aspen 2 Mode D'emploi

Aspen 2
English

1. Instructions for assembly of the Aspen VCA superstructure

Attention!: Caution: Disconnect power to the cabinet before performing any operation.
Equipment necessary for assembly:
Screwdriver – Allen wrenches 2/3/4.
To assemble the superstructure for the Aspen cabinet, proceed as follows
1 Unpack
2 Place the upright of the superstructure in the
housing on the side of the cabinet.
3 Fasten carefully not completly the upright of
the superstructure to the housing on the side
of the cabinet..
4 A - Insert the U-shaped profile on the
longitudinal edge of the curved front glass.
B - Apply the polyurethane
gasket.
36
A
B
:
05060096 02 03/08/2015