After Usage - Boneco S450 Instructions D'utilisation

Cleaning
en
Always disconnect the power plug of the appli-
ance, before cleaning or rinsing (15).
The unit has to be completely emptied and
cooled off. Caution: Danger of burning!
Caution: Never pour any water into the ventila-
tion openings since this can damage the appli-
ance (24 – 25).
Important: Do not use any abrasive objects
(knives etc.) or sponges to clean the steam tray.
Never immerse the appliance in water or any
other liquids (16).
• Regular cleaning is essential for hygienic, problem-free
operation.
• Depending on water quality, regular decalcification of
the appliance is recommended (see Decalcification-
Mode).
12
Cleaning of water tank and covers –
weekly (15 – 25)
Clean the water tank, top cover, fragrance
container and steam pipe with a soft plastic
brush and dish detergent and rinse well (17).
Decalcification-Mode
Only use EZCal and EZCal PRO for decalcification. Damage
that is caused by the use of other cleaning agents is not
covered by the warranty.
The Decalcification-Mode enables simple cleaning and
decalcification of the steam tray, water base, and steam
pipe.
The Anti-Mineral Pad needs to be removed, before starting
the Decalcification-Mode (18) (see section about Anti-
Mineral-Pad). Dissolve the EZCal or EZCal PRO decalcifi-
cation agents in warm water (EZCal: 32 oz / 1 L; EZCal
PRO: 14 oz / 0.5 L) and pour into the water base (19). Then
reinsert the steam pipe and top cover (20). Pressing and
holding button A for 5 seconds switches the appliance to
Decalcification-Mode (21). Decalcification-Mode is shown
on the display by the flashing symbol E (22). The value "4h"
is shown flashing on the display. Button C can be used to
change the decalcification period from 1h to 9h, depending
on the level of soiling (22). After 3 seconds without further
input, the set value is taken as "desired value" and the flash-
ing display changes back to "CURRENT". The unit heats
up the EZCal and EZCal PRO-water solution during De-
calcification-Mode and shuts off after it is finished. The
heating of the water takes place every 30 minutes while
the Decalcification-Mode is active. The cleaning period
is now permanently displayed and switches to minutes
when the time falls below the 1 hour mark. The clean-
ing period can be changed at any time by pressing but-
ton C. At the end of the cleaning period, a short double
signal is sounded, the display shows the value "0h"
and the cleaning symbol F will rapidly flash (23). Press-
ing button A ends the Decalcification-Mode and switches
off the appliance (23).
CAUTION: The water base must now be emptied of the
EZCal and EZCal PRO and rinsed (24 – 25). Make sure no
water enters through the ventilation opening (25). Tip: In
case of excessive lime scale, decalcify overnight (12 to 15
hours).
Cleaning the housing – once or twice
annually (26).
Clean the housing with a damp rag and wipe it dry; use a
cleaning agent suitable for plastic if needed.

After usage

• Switch the appliance off by pressing button A (27).
• Disconnect power plug (15).
• Wait until the appliance has completely cooled off.
• Empty any remaining water and clean the water tank
and the water base. Decalcify if necessary.
• Let the appliance dry.