Control Panel Operation - Chauvet SCORPION GBC EU Manuel D'utilisation

4. O
PERATION
Control Panel
Operation
Menu Branches
Changing
Options (Current
Menu Branch)
Changing
Options
(Different Menu
Branch)
Scorpion™ GBC EU/RBM EU/RGY EU/BLU EU User Manual (Rev. 5 ML)
To access the control panel functions, use the four buttons located underneath the
display.
Button Function
Press to find an operation mode or to
<MENU>
back out of the current menu option
Press to scroll up the list of options or
<UP>
to find a higher value
Press to scroll down the list of
<DOWN>
options or to find a lower value
Press to activate a menu option or a
<ENT>
selected value
The menu structure of the Scorpion™ GBC EU/RBM EU/RGY EU/BLU EU fixtures has
seven branches. Because the Scorpion™ BLU EU has a single color laser, its menu
branches have fewer options than the other models.
The structure of the menu branches is as follows:
•
Auto/Sound: 13 options (4 options for the BLU EU model)
•
Laser Sky Mode: 4 options (2 options for the BLU EU model)
•
Laser Sky Angle: 1 option (all models)
•
Sound Sensitivity: 10 options (all models)
•
DMX address: 503 options (all models)
•
Slave: 1 option (all models)
•
Reverse: 2 options with two values each (all models)
•
The control panel will remember the last setting you programmed, even after
you have turned the fixture off.
•
In addition, the control panel will remember the last selected option from each
menu branch.
To change an option on the same menu branch, do the following:
1. Press <MENU> once (the LED display will blink).
2. Press <UP> or <DOWN> until the desired menu option shows on the LED display.
3. Press <ENT> to accept the new option (the new option will show solid on the LED
display).
To change an option on a different menu branch, you must exit the current branch.
1. Press <MENU> once (the LED display will blink).
2. Press <MENU> repeatedly until seeing the active option of the desired menu branch.
3. Press <UP> or <DOWN> until the desired menu option within the new menu branch
shows on the LED display.
4. Press <ENT> to accept the new option (the new option will show solid on the LED
display).
Page 13 of 68