Rotary Switch; Switching On/Off - Boneco W2055A Instructions D'utilisation

Filling the tank
Do not operate the appliance when the water
tank is empty!
• Remove the water tank (21).
• Ensure that there are no foreign objects in the water
tank.
• Remove the water tank cap from the tank (22). Fill the
en
tank with fresh, cold tap water (23). Fully close the
bayonet seal to prevent the water tank from leaking
(24). Place the water tank on the water base (25). Do
not add any additives to the water!
• Do not pressurise the water tank, e.g. by filling it with
carbonated mineral water.
• Connect the mains cable to the mains and switch the
appliance on.
The appliances are fitted with an automatic cut-off switch.
As soon as the water base is empty, the unit switches off
automatically. The empty indicator illuminates (also see
section «Operation»).
Use of fragrances
The base contains a special fragrance container (26). Wad-
ding soaked with fragrance can be placed in this container.
Place fragrances only in the container provided! Water ad-
ditives (e.g. essential oils, fragrances, water conditioners)
must NOT be used in the tank or anywhere else in the appli-
ance! Even a small amount can damage the plastic or cause
cracks. The material is not suitable for the use of additives.
One drop is enough to damage the water tank and therefore
render the unit unusable. Appliances that are damaged by
additives are excluded from the warranty. The fragrance
container is also used as a tool for opening the rotary locks
of the humidifying disks. To learn more about removing the
disks, refer to section «Cleaning the humidifying disks».
20
Water quality maintenance (ISS)
®
The Ionic Silver Stick (ISS) utilizes the antimicrobial prop-
erty of silver and provides one season of optimum water
quality maintenance in all BONECO humidifiers. The ISS
begins working as soon as it comes into contact with wa-
ter – even if the unit is switched off. The ISS is intended
exclusively for use in humidifiers. Look at picture 27 for the
position of the ISS in the appliance.
Lifecycle indicator
Your appliance comes with a standard lifecycle indicator
on the back of the upper part for changing the Ionic Silver
®
Stick . To remind yourself of when you put the ISS into
operation, please cross the current month on the indicator
and write the current year on the line provided.
Operating W2055A
B C D
A
A) Rotary switch
Connect the appliance to the mains and turn rotary switch
A to position C or D as required. To switch the appliance off,
turn the rotary switch to position B.
B) Switching on/off
If the rotary switch is in position B, the appliance is swit-
ched off.
C) Normal mode
If you select position C, then normal mode is set, and the
appliance reaches maximum humidity output.
D) Night mode
If you turn the rotary switch to position D, the appliance
works in night mode and is especially quiet.
E) Operating light
The green light (LED) (E) illuminates when the appliance
is switched on. When the water level is low, the appliance
automatically switches off. The LED display changes from
green to red. The appliance automatically continues opera-
ting when filled with water. (Also see 2nd paragraph of point
F in operation W2055D).
E