Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
4.3 Switching on/off Picture A
► Always guide the machine with both hands.
Switch on first, then guide the accessory towards
the workpiece.
Avoid inadvertent starts: always switch the tool off
when the plug is removed from the mains socket or if
there has been a power cut.
► In continuous operation, the machine continues
running if it is forced out of your hands.
Therefore, always hold the machine with both hands
using the handles provided, stand securely and con-
centrate.
Avoid the machine swirling up or taking in dust and
chips. After switching off the machine, only place it
down when the motor has come to a standstill.
► Torque activation
Switching on: Slide the lock (7) in the direction of the
arrow and press the trigger switch (8).
Switching off: Release the trigger switch (8).
Continuous operation (depending on features)
Switching on: Slide the lock (7) in the direction of the
arrow, press the trigger switch (8) and keep
it pressed. The machine is now switched on. Now slide
the lock (7) in the direction of the arrow once more to
lock the trigger switch (8) (continuous operation).
Switching off: Press the trigger switch (8) and release.
5.0 Transport
To avoid injury dismount the blade while transporting
the machine. Pull out the plug from the mains.
6.0 Maintenance
Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean. The machine
must then be sent to an after-sales Service agent.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
18
Addresses are listed in the Section "After- sales
service and customer assistance".
► The motor is equipped with shut-off charcoal which
shuts off the motor when the wear limit is reached.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specified on the
type plate of the machine.
6.1 Spare parts
Spare parts can be found on the internet at:
http://webkatalog.wolff-tools.com
7.0 Trouble shooting
Fault
Possible cause Remedy
The machine
does not start
Higher exer-
tion of force
required while
working
8.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste! Ac-
cording the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national right,
www.wolff-tools.de
Power supply
Contact Electrici-
interrupted
an.For repair and
Defective cable
/or replace parts
Defective plug
Cutting bla-
Replace
de dull
cutting blade
or resharpen
Publicité
Table des Matières
