WOLFF PRIMO-STRIPPER 230 Traduction Du Mode D'emploi Original page 19

power tools that are no longer usable must be collected
separately and disposed of in an environmentally correct
manner.
Subject to change without notice
9.0 Notes on various fl oor coverings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The PRIMO-STRIPPER is primarily used to remo-
ve linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched fl oor cover-
ing and carpeted fl ooring.
Hardwood parquet, multi-layer parquet, semifl exib-
le and ceramic tiles can also be removed to a limi-
ted extent.
► Needle-punched fl oor covering, carpet, PVC.....
The coverings to be removed should be pre-cut in
blade-widths (Pic. C) and then removed with the
stripper in one step. In many cases, the glue can
also be removed at the same time.
► Coverings without a foam backing:
Prior to performing the stripping work, pre-cut the
strips in blade-widths (Pic. C). Regularly check
whether the blade is still straight and sharp.
► Coverings with a foam backing:
Only use sharp blades! Remove the large Sections of
the wearing surface. Use a carpet pulling claw for this.
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from the
side.
► Coverings with a fl eece backing:
Do not remove the wearing surface beforehand. Cut
the covering into strips and strip them together with
the fl eece backing.
Important blade recommendation:
In general, no statements can be made on which
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
blades can be used for which blades, because the
variety of coverings and surfaces are too diverse.
These recommendations are to provide assistance!
Warning
► We recommend using fl at blades of varying lengths
and widths for fl exible, elastic fl oor coverings. The
harder the covering, the thicker the blade should be.
► The blade is generally inserted with the blade edge
up, unless it works itself too deep in the surface. In
this case, the blade must be inserted with the blade
edge down.
10.0 Guarantee
The warranty period for new Wolff machines shall last for
one year from the point at which the machine is transfer-
red / delivered to the customer, insofar as statutory legal
requirements do not stipulate otherwise.
When validating warranty claims, the invoice or proof of
purchase must always be submitted.All repairs within the
framework of the warranty agreement must be undertaken
by a service Centre that has been accredited by us.
Customers performing their own repairs and/or improper
repairs regularly lead to the exclusion of warranty claims.
The same also applies to incorrect operation and/or use.
Replacement of parts, accessories and other modifi ca-
tions to Wolff machines
Users of Wolff machines enjoy a high level of safety and
reliability of their machine. In order to maintain this status
quo, your Wolff tool may not be modifi ed from the condition
in which it is delivered without following the rules below.
These rules apply to both the replacement of parts and
equipping the machine with accessories as well as other
technical modifi cations.
 All work undertaken to your Wolff machine must be
undertaken exclusively by a workshop that has
suitably trained and experienced personnel at its
disposal, as well as the requisite work equipment.
We recommend using authorised service Centre.
 In the event of planned replacement of parts, planned
addition of accessories or other planned technical
www.wolff -tools.de
EN
19