Getting Started; Initial Setup; Power Input - CareFusion Alaris DS Mode D'emploi

A Before operating the Docking Station read this Directions For Use manual carefully.
1. Check that the Docking Station is complete, undamaged and that the voltage rating specified on the label is compatible with your AC
power supply.
2. Items supplied are:
Alaris® DS Docking Station
Directions For Use
Protective Packaging
The Docking Station has its own power distribution circuit. The AC is supplied via a standard IEC connector into the power tile. An
illuminated isolator mains switch shows when the power is on.
The Docking Station has a double fuse holder protecting the AC inlet. Both the mains and neutral supply are protected by fuses.
If the LED on an infusion pump tile is active when no pump is attached to the tile, suspect a fault with the power
A
supply to the tile. Remove the Docking Station from service and contact a qualified service engineer.
The adjustable height pole has been designed as a convenient means of securing the fluid bags onto the Docking Station. The pole
supports a maximum load equivalent to 2.5 kg per bag hanger (2 kg when being transported on a trolley). The pole is held securely by a
clamp and a slip catch. This gives additional flexibility when selecting the required height of the fluid bags. To operate the clamp:
1. Grip the handle at the lower end of the pole and carefully loosen the hand wheel.
2. Holding the pole, release the slip catch; this will allow the pole to move freely.
3. Adjust the pole so that the fluid bag will be suspended at the desired height.
4. Tighten the hand wheel to securely lock the pole into position.

Getting Started

Initial Set-up

Power Input

Adjustable Height Bag Hangers
1000DF00444 Iss. 2
7/210