Installing Grease Trays And Filters - Thermador VCIN36GWS Instructions D'installation

Installing Grease Trays and
Filters
1
6
(1) LED lights
(3) Baffle filters
(5) Grease tray trough
Install Filters and Grease Trays
NOTE: DO NOT use burners, elements, or oven while
hood is disassembled.
1. Turn the fan and lights off.
2. Remove all plastic from hood pieces.
3. Insert in the following order:
a) Grease tray — Insert in rear tray. Grease trays
must be in place before installing the filters. Push
the grease tray in and down inside the grease tray
trough.
-- The small grease tray must be installed in the
.
center of hood
Page. 19
2
3
4
5
(2) Touch control panel
(4) Grease trays
(6) Filter spacers
b) Filters — start with inserting the filter in the
middle and work out to the ends. Slide the filter
up, toward the front of the hood, then push down
on top of the grease tray .
-- The 8" filter must be installed in the center of
hood at all times.
3
c) Filter spacers — If applicable, insert the filter
spacers on the left and right ends. Push up, slide
toward the front of the hood, then push in at the
bottom.
Reverse the above directions to remove the grease trays
and filters. Ensure filters are cool and grease has
congealed before removal.
2
1