Zanussi ZDI11002 Notice D'utilisation page 20

• Make sure that the spray arms can move freely before
you start a programme.
Using the detergent
Caution! Use only detergents for dishwashers.
Do not use more than the correct quantity of deter-
gent. Refer to the instructions on the detergent
packaging.
1
A
3
Put the detergent or the
tablet in compartment (A).
B
If the programme has a
prewash phase, put a
small quantity of detergent
in compartment (B).
Detergent tablets do not fully dissolve with short
programmes and detergent residues can stay on the
dishes.
We recommend that you use detergent tablets with long
programmes.
20
2
A
4
Combi detergent tablets
These tablets contain detergent, rinse aid and other added
agents. Be sure that these tablets are applicable to the wa-
ter hardness in your area. Refer to the instructions on the
packaging of the products.
When you use tablets, that contain salt and rinse aid, do
not fill the salt container and the rinse aid dispenser.
1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest position.
If you stop to use the combi detergent tablets, before you
start to use separately detergent, rinse aid and dishwasher
salt, do these steps:
1. Turn the programme knob until the programme mark-
er is aligned with the shortest programme with a rins-
ing phase.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the set programme, without detergent and with-
out dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to start a
programme.
• Turn the programme knob until the programme marker
is aligned with a programme on the control panel. If the
on/off indicator comes on and the phase indicators for
the programme start to flash, the appliance is in setting
mode.
• Turn the programme knob until the programme marker
is aligned with a programme on the control panel. If the
on/off indicator and the start indicator come on and a
phase indicator is on with fixed light, the appliance is
not in setting mode.
To put the appliance in setting mode, press and hold the
start button until the start indicator goes off and the phase
indicators for the programme start to flash.
Starting a programme without delay start
1. Open the water tap.
2. Close the appliance door.