IKEA TVARSAKER Mode D'emploi page 35

EN
To set a self clean cycle:
1. Be sure the oven is empty and all oven racks are
removed. Remove all items from the oven. Be
sure oven door is completely closed.
2. Press Self Clean. The default 3 hour clean time
will appear in the display. You may accept the
3 hour clean time or choose a different clean
duration by entering any time between 2 and 4
hours clean time by entering the time using the
numeric keys.
3. Press OK/START. The warning to REMOVE
RACKS will flash in the display to remind you
that oven racks should be removed before a self
clean.
4. Press OK/START to activate self clean.
Important: Do not open the oven door while the
lock motor is running or when any locking indicators
or displays are showing. The oven door is completely
locked in about 15 seconds. Once the oven door has
locked, CLEAN will appear in the display indicating
self clean has started.
Do not force the oven door open when self-clean is
active. This can damage the automatic door-locking
system. Use caution when opening the door after
self-clean cycle is complete; the oven may still be
very hot.
When self clean is finished:
1. CLEAN message will turn off, and Hot will appear
in display window.
2. Once the oven has cooled down (about 1 hour)
and Hot is no longer displayed, the oven door
may be opened.
3. When the oven interior has completely cooled,
wipe away any residue or powdered ash with a
damp cloth or paper towel.
CAUTION
To avoid possible burns, use care when opening
the oven door after the self cleaning cycle. Stand
to the side of the oven when opening the door to
allow hot air or steam to escape
Setting Delay Start Self Clean
To start a delay self clean with default clean
time of 3 hours and a start time of 9:00 o'clock:
Be sure the clock is set with the correct time of day,
the oven is empty, and all oven racks are removed.
Be sure oven door is completely closed.
1. Press Self Clean.
2. Press Delay Start.
3. Using numeric keypad, enter 9 0 0.
4. Press OK/START to accept.
If it becomes necessary to stop self clean when
active:
Press OFF.
If Self Clean has heated the oven to a high
temperature, allow enough time for the oven to cool.
Before restarting self clean, be sure to read impor-
tant notes below.
NOTE
If your clock is set with the (default) 12 hr display
mode, the delay start for a self clean can only be
programmed to start up to 11 hours and 59 min-
utes after the time showing in the display (be sure
to set the clock to current time before program-
ming a Delay Start).
To set a Delay Start self clean to begin 12 or more
hours (maximum is 23 hours and 59 minutes) after
the time of setting, be sure to first set the control
in the 24 Hr display mode.
If self clean was active and then interrupted by
a power failure or cancelled before the oven was
thoroughly cleaned, it may be necessary to run
another self clean cycle.
If the oven temperature was high enough when
self clean was interrupted the oven control may not
allow another self clean cycle to be set for up to 4
hours.
OVEN CONTROLS
35