Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Controls
The controls will look like one of the following.
Warmer
Cooler
Thermostat
16 Room Air Conditioner
Heater
Operation
AUTO SWING (for some models)
ON (
) : Air swing is operated while
OPERATION knob is set to the COOL
or HEAT position.
OFF (
) : Stops the operation of air swing.
THERMOSTAT
Turn the thermostat control to the desired
setting. The control position is a normal setting for
average conditions. You can change this setting, if
necessary, in accordance with your temperature
preference.
The thermostat automatically controls cooling or
heating, but the fan runs continuously
whenever the air conditioner is in operation. If the
room is too warm, turn the thermostat
control clockwise. If the room is too cool, turn the
thermostat control counterclockwise.
HEATER (
When the unit sets heating operation condition, the
green lamp is lighted.
When the frost settles on the heat exchanger of the
outside, defrosting is made automatically and the
green lamp is turned off.
The unit may give a "hiss" and the fan motor stops
for 1 to 10 minutes.
This should not be regarded as a problem.
After defrosting, the heating operation begins again.
OPERATION
o
OFF
(
) : Turns the air conditioner off.
LOW FAN
(
) : Permits the low fan speed
operation without cooling
(heating).
LOW COOL (
) : Permits cooling with the low
fan speed operation.
HIGH COOL (
) : Permits cooling with the high
fan speed operation.
LOW HEAT (
) : Permits heating with the low
fan speed operation.
HIGH HEAT (
) : Permits heating with the high
fan speed operation.
CAUTION: When the air conditioner has
been performed its cooling operation and is
turned off or set to the fan position, wait at
least 3 minutes before resetting to the
cooling operation again.
) LAMP
Publicité
Chapitres
Table des Matières
