LG TWC226NBAB5 Mode D'emploi page 11

Install the Air Conditioner in the Case
1. Slide the air conditioner into the case.
Reinstall the 2 screws removed earlier on each
side of the case.
Screw
Power Cord
CAUTION: The power cord must be
connected to an independent circuit.
The green wire must be grounded.
2. Stuff the foam between the top of the unit and the
wall to prevent air and insects from getting into the
room.
3. Before installing the front grille, pull out the vent
control lever located above the unit control knobs,
as shown. (for some models)
4. Attach the front grille to the case by inserting the
tabs on the grille into the slots on the front of the
case. Push the grille in until it snaps into place.
When you detach the front grille from the case,
push the grille to your right side and pull it toward
you.
Screw
5. Lift the inlet grill and secure the front grille with a
The Foam
screw(L:10mm). Lower the inlet grille into place.
(for some models)
Installation
Owner's Manual 11