Service; Accessories - Dustcontrol DC 5800a Mode D'emploi

Service

With cleaning and maintenance on the machine, the power
cable should be disconnected from the supply. Check regu-
larly that the electrical cable is not damaged.
Th e fi ne fi lter should be changed at least once per year. Use
only original spare parts. If the machine is used with a micro-
fi lter/HEPA fi lter, this should be changed every 300 running
hours.Use breathing protection when changing the fi lter.
Care must be taken during the fi lter change not to expose
unprotected persons to harmful dust. Used fi lters should be
sealed in a plastic sack and disposed of properly.
Th e DC 5800a/c should be performance tested at least once
per year because it may be used with hazardous materials.
Worn parts must be replaced.

Accessories

Description
Plastic sacks, standard
Fine fi lter polyester
Fine fi lter
Microfi lter
Warranty
Th e warranty period for this machine is two years and co-
vers manufacturers faults. Th e warranty is valid under the
condition that the machine is used under normal conditions
on the task for which it was designed and is maintained
properly. Normal wear is not covered by this warranty.
Part No
4614
429204
4292
4422
DC 5800a 5 kW - 10
Never compromise the function of the DC 5800a/c, use
only original spare parts.
Th e turbopump has a very long maintenance free ser-
vice life. After approximately 10 000 running hours,
the radial seal between the motor and pump housing
should be greased. Bearings and seals in the motor and
turbopump should be checked and lubricated. Parts
worn beyond serviceable tolerances should be replaced
with genuine spare parts.
Other accessories — see Dustcontrol catalo-
gue.
Service performed by other than Dustcontrol or its aut-
horized agent voids automatically the warranty. No other
warranty express or implied is applicable.
Part No 9481