Start-Up; Working Instructions; Cleaning And Maintenance; Maintenance - Parkside PFR 28 A1 Traduction Des Instructions D'origine

GB
Connection with adapter
1. Attach the adapter (1) to the
extension element (4) or the con-
necting element (
it through 90° until it locks into
place (bayonet locking device).
Screw the cap nut (3) of the ex-
tension element (4) against the
adapter (1).
2. Connect the spray gun (bayonet
locking device) and screw the
cap nut (2) of the adapter (1)
against the spray gun.
To release
1. Release the retainer nut of adapter
( 2) on the adapter (
2. Loosen retainer nut (
extension element (
3. Release the catches by pushing
and turning through 90° in the op-
posite direction (Bayonet catch).

Start-up

Working instructions

Take heed of the backstroke gen-
erated by the jet of water. Stand
firmly and hold the jet gun tightly.
You may otherwise injure yourself
or others.
• Do not release water from the pressure
washer until the patio cleaner rests on
the surface you are cleaning.
• Always hold the patio cleaner by the
handle (5) when washing down walls.
28
•
•
5) and turn
Pressure control
1).
Cleaning and
3) on the
4).

Maintenance

Cleaning

Always keep the washer clean. Do
not use any detergents or solvents.
•
Maintenance
The device is maintenance-free.

Storage

•
Avoid the patio cleaner going over
free corners.
The patio cleaner is not designed for
scouring out or scrubbing.
1. You can adjust the pressure of
the escaping water jet by turning
the pressure regulator (9). Accor-
dingly, the rotation speed of the
nozzles changed
2. Increase the pressure (+) by tur-
ning the pressure regulator (9) in
a clockwise direction. Reduce the
pressure (–)
counterclockwise connnections.
Always remove the mains plug of
the high pressure cleaner before
working on the device. There is a
risk of electric shock or injury from
moving parts.
Only clean the pressure washer with a
soft brush or a slightly moist cloth.
Store the device in a frost-free room.
by turning the screw