Sound Signals - RIB MASTER WI-FI ACG6094 Mode D'emploi

G
B
SUN 2CH
Code ACG6052
SUN 4CH
Code ACG6054
The Wi-Fi System complies with the standard EN13849-2:2008 and
together with a RIB electronic control panel is a Class 2 protection
device.
The Wi-Fi System through the use of the MASTER Wi-Fi card permits
the construction of a system with NOVA Wi-Fi photocells and TOUCH
Wi-Fi strips which also attach to the moveable panel without the
need for a cable collector.
The system constantly monitors the presence of the various safety
devices and the status of the batteries, completely meeting the need for
active safety for all types of openings.
Using the RIB electronic control panel it is possible for the system to
perform an auto test as required by current standards.
Each radio-controlled safety device has its own internal identification code
which distinguishes it from the others.
R
EFERENCE STANDARDS FOR AUTOMATIC DOORS AND
GATES
The installer must ensure that the Wi-Fi System is connected as specified
by the standard EN12453 as per 5.1.1.6 (points e and f) to an electronic
control panel capable of performing an operations check before closing
(AUTO TEST).
Therefore, the use of RIB devices permits system installation in compliance
with current Standards and Directives.
Once machine installation is complete it must be ascertained that it
complies with standard EN13241-1.
RIB may not be held responsible for any damage caused by improper,
wrong or unreasonable use of the product.
M
ASTER Wi-Fi
This is the heart of the system: it runs all of the control (433,92 MHz),
safety and signaling (868,3 MHz) devices programmed in the installation
phase.
MASTER Wi-Fi is available in two versions:
- MASTER Wi-Fi with connection couplings (code ACG6094), for use
with all non-CRX RIB electronic control panels.
- MASTER Wi-Fi with terminal block (code ACG6099), for use with other
brands or RIB CRX panels.
MOON 2CH
Code ACG6081
MOON 4CH
Code ACG6082
NOVA Wi-Fi
Code ACG8037
SPARK Wi-Fi
Code ACG7064
S
AFETY DEVICES
MASTER Wi-Fi can operate up to 6 safety devices (NOVA Wi-Fi + TOUCH
Wi-Fi) at the same time.
- NOVA Wi-Fi photocells (code ACG8037): can be connected to a
TOUCH mechanical strip (code ACG3015) or a resistive strip on both
the photocell transmitter and the photocell receiver.
- TOUCH Wi-Fi strip (code ACG3016), with built-in transmitter/receiver.
C
ONTROLS
MASTER Wi-Fi runs up to 100 different remote control codes:
- MOON dual-channel 433,92 MHz remote controls (code ACG6081)
- MOON four-channel 433,92 MHz remote controls (code ACG6082)
- MOON CLONE 433,92 MHz remote controls (code ACG6093)
- SUN dual-channel 433,92 MHz remote controls (code ACG6052)
- SUN four-channel 433,92 MHz remote controls (code ACG6054)
- BLOCK Wi-Fi mono-channel 433,92 MHz key selector switch (code
ACG6098).
MOON remote controls may be coded with a single code.
It is also possible to connect a wired control with N.O. contact.
V
ISUAL SIGNALS
MASTER Wi-Fi can operate a SPARK Wi-Fi Blinker (868,3 MHz) code
ACG7064, thereby completing automation.
MASTER Wi-Fi has LEDs for monitoring system status and for identifying
photocells or strips with low or exhausted batteries.
S
OUND SIGNALS
MASTER Wi-Fi has a buzzer which signals installation phases and a
warning if the batteries are low or exhausted or, acts as an alarm in case
one of the devices is not functioning.
The use of the product inside of metal containers can cause a
system-malfunction. It is therefore recommended in these cases
to add the aerial code ACG5451 to apply to the metal casing for a
perfect reception/transmission of the signals.
18 18
18 18
MOON CLONE
Code ACG6093
BLOCK Wi-Fi
Code ACG6098
TOUCH Wi-Fi
Code ACG3016