Troubleshooting; Declaration Of Conformity - Klarstein 10028105 Mode D'emploi

Cleaning the Mixing Jug
1. Fill the mixing jug with about 1 liter water by adding a few drops of dishwashing liquid. Water with
dishwashing liquid will foam up during heating and mixing, so don't add too much liquid.
2. Heat up the water for about 8 minutes at cooking setting HIGH.
3. Press the blend button briefl y.
4. Allow the water to cool before cleaning the inside wall of the mixing jug.
5. Clean the mixing jug from the inside with the cleaning brush.
6. Rinse off the mixing jug with clean water and carefully dry it off .
Clening Lid and Cap
Clean these components in a rinsing bath. Rinse with clean water an dry off the parts.
Storage of the Appliance
• Clean the device as described. Let the accessories dry completely.
• We recommend that you store the device in its original packaging when it is not to be used for a
longer period.
• Always store the device at a well ventilated and dry place outside the reach of children.
Malfunction
The device does
not function.
Liquids are not
mixed correctly.
The blades
become blocked
after turning on.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
13

Troubleshooting

Possible cause
The device is not supplied with
power.
The device is defective.
You have too much or too little
liquid in the vessel.
The speed is too high.
The selected speed is too low.

Declaration of Conformity

Remedy
Check the outlet with a diff erent device.
Insert the power plug correctly.
Check your domestic fuse.
Contact our service or a specialist.
Vary the quantity of the liquid.
Start with a lower speed which you can
increase later.
Start at a higher speed.