Trimming The Model; The First Touch-Down; Maintenance And Care; Declaration Of Conformity (Doc) - Reely SKY SlowFlyer RtF Notice D'emploi

c) Trimming the Model
If your model tends to drift to one direction in straight flight, correct the neutral position of the corresponding rudder by trimming.
Rudder:
If the model drifts towards the left, push the right rudder trim button (see figure 2, item 6) repeatedly until the model flies straight. If the model now pulls to the
right, push the left button.
Elevator:
Set the elevator trim buttons (see figure 2, item 4) so that the model rises in a flat angle at full motor speed and maintains the altitude at reduced motor speed.
If the model rises too much, push the front trim button. If the model tries to dip down with its tip all the time, push the rear trim button.
The remote control issues a short signal every time a trim button is pushed.
At the end of the trim range, there will be a quick sound sequence.
A total of 17 separation steps are available for every trim range.
The last trim value set is automatically saved and called again after related activation of the remote control.
d) The First Touch-Down
Reduce the motor speed and fly in wide and flat circles. Do not pull on the elevator too hard to reduce the flying altitude slowly. Select the last curve before
approaching for a landing so that, in case of an emergency, you would have sufficient room for landing and so that you would not have to make any considerable
corrections to the course during the approach for a landing.
Always ensure sufficient flying speed and do not slow down the model reducing the motor speed too much or by pulling too hard at the elevator. It is only briefly
before touch-down that the motor is stopped and the model lands with the elevator fully pulled.


15. Maintenance and Care

Regularly check the functional safety of your remote control and smooth running of the gear motor. All moving parts have to be easily movable but there should
not be a clearance in the bearing.
Clean the exterior of the model and the remote control only with a soft, dry cloth or brush. Never use aggressive cleansing agents or chemical solvents, since this
might damage the surfaces.
Important!
If you have to replace any damaged or worn parts, only use original replacement parts.
The spare parts list is located on our website www.conrad.com in the download section to the respective product.
You can also order the replacement parts list by phone. For contact information, please refer to chapter "Introduction" at the beginning of these operating
instructions.


16. Declaration of Conformity (DOC)

The manufacturer hereby declares that this product complies with the essential requirements and regulations and all other relevant provisions of the 1999/5/EC
directive.
The compliance statement for this product is available at www.conrad.com.
33