Important Safety Instructions - SEVERIN HT 0112 Mode D'emploi

GB
Hair dryer
Dear Customer
Before using the appliance, the user must read
the following instructions carefully.
Connection to the mains supply
The hair dryer should only be connected to
a socket installed in accordance with the
regulations.
Make sure that the supply voltage corresponds
with the voltage marked on the rating label of
the hair dryer.
This product complies with all binding CE
labelling directives.
Familiarisation
1. Air intake opening, detachable
2. Air temperature control
3. Air fl ow control
4. Hanging loop
5. Flexible non-kink covering
6. Power cord
7. Cool function
8. Volume diffusor
9. Styling nozzle
10. Air outlet openings

Important safety instructions

■
Caution: do not use the
appliance in the vicinity of a
bath, shower or swimming-
pool, over a washbasin fi lled
with water or near any other receptacle
containing water.
Protect the appliance from moisture and
splashing water and do not operate it with
wet hands.
■
In the vicinity of any water source, there is
a risk even when the appliance is switched
off. Therefore, always remove the plug from
the wall socket after use, especially if the
appliance is being used in a bathroom.
■
For additional protection, the installation
of a residual current device (RCD) having
a rated residual operating current not
exceeding 30 mA is advisable in the
electrical circuit supplying the bathroom.
Ask your installer for advice.
■
Electric heating appliances operate at very
high temperatures. Do not touch any part
of the appliance except the grip. Otherwise
there is a real risk of burning.
■
Do not use the appliance on synthetic hair-
pieces or wigs, as the heat emitted might
cause damage to the synthetic fi bres.
■
Make sure the air intake and outlet
openings are not blocked (e.g. by fi ngers or
hair), and that no fl uff or fi bre particles are
allowed to accumulate in the air intake.
■
A blockage in the air-fl ow system may
cause the integral thermal safety cut-out to
switch off the appliance. Should this occur,
immediately disconnect the appliance from
the mains power and allow suffi cient time
for it to cool down before the blockage is
removed and the appliance is switched on
again.
■
Every time the appliance is used, the main
body including the power cord as well as
any attachment fi tted should be checked
thoroughly for any defects. Should the
appliance, for instance, have been dropped
onto a hard surface, it must no longer be
used: even invisible damage may have
adverse effects on the operational safety of
the appliance.
■
To prevent damage to the power cord,
- do not bend or kink the cable, especially
where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
■
Do not leave the appliance unattended
while in use.
■
Always switch off and remove the plug from
the wall socket after use, as well as
- in cases of malfunction, and
- during cleaning.
9