Location Of Your Washer; Unpacking - Frigidaire LTF2940FE Notice D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DO NOT INSTALL YOUR WASHER:
1. In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. In an area where it will come in contact with curtains or drapes.
3. In an area (garage or garage-type building) where gasoline of other flammables are kept or stored (including automobiles).
4. On carpet. Floor MUST be solid with a maximum slope of 1/2 in. per foot (1.27 cm per 30.5 cm). To ensure vibration or
movement does not occur, reinforcement of the floor may be necessary.
IMPORTANT
MINIMUM INSTALLATION CLEARANCES
When installed in alcove or closet:
Sides, Rear = 0 in. (0 cm)
Top = 0 in. (0 cm)
When installed in closet: Front = 1 in. (2.54 cm)
Closet door ventilation required: 2 louvered openings each 60 in
1. Cut the shipping carton along the dotted line along the bottom. Remove the carton.
2. Using a rug, blanket or piece of cardboard to protect the floor, lay the washer on it's back.
3. Remove and save the styrofoam base and shipping plug.
Base

LOCATION OF YOUR WASHER

UNPACKING

Shipping
Plug
(387 cm
2
), 3 in. (7.6 cm) from top and bottom of door.
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ltf2940fs1

Table des Matières