Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
48
If all preparations hav
connected to the main
point. Beforehand che
check if the turning dire
ge once more and see i
necessary you have to
there is no paper or cle
nings of the motor. Ch
basins cannot come ou
PUT THE JA
PLACE!
Open the pro
and tension of the belts
ning speed has to be c
watch fig.5 and 15.
Push in the switch and
minutes. Check regula
stock and the motor d
machine and putting a
and on the motor body
viating noise and if you
ment( more than hand
plier.
Then switch over to a h
also function a few mi
with a reversed turning
sen, the machine is rea
WORKING METHOD
Removing metal takes
chisel point or a boring
which small pieces of m
this the piece of work h
tween two fixed turning
stock (watch fig.1) - wh
line: the centerline(4).
the centerline over the
which has been fixed o
along the turning piece
straight line, with the ha
mission(6).
For removing material
ded. This power is tran
shaft in the headstock
with the maximum mo
which has to be taken -
chip- has to be adapte
wers too much, the sta
to be lowered. Otherwi
ge, shorter tool life of t
diameter of the piece o
have a diamter of 100
ting a chip of 1 mm than
When the tail stock (8)
cause of cross adjustm
ned. An extra processi
cutting a screw-thread
pening in the outline of
Ferm
Ferm
Publicité
Table des Matières
