Accessories And Spare Parts - Ferm MD-350 Mode D'emploi

ONDERDELENOVERZICHT
APERÇU DES PIÈCES DÉTACHÉES
Ferm Ferm
SPARE PARTS SURVEY
ZUBEHÖRVERZEICHNIS

ACCESSORIES AND SPARE PARTS

ACCESSORY NR FUNCTION
Lower case 330957 with store possibilitiesand cutting
tray
3-Jaw chuck 330955 clamping pieces of work which
are round
4-Jaw chuck 330956 clamping pieces of work which
are not round
Steady rest 330962 turning long pieces of work
Follow rest 330965 turning long and thin pieces of
work
Face plate 330968 Fixing pieces which are not round
Accessories-set 400375 as delivered with machine
Center 400368 MT-3
Center 400369 MT-2
Inside basin 3-jaw 400377 set
Outside basin 3-jaw 400376 set
V-belt tension 400374 complete
Gear rack 400346 steel
Gear rack 400366 synthetic
Inch gear wheel set 330961 Thread cutting
Change wheel scissors 40031 steel
Handwheel 400404 synthetic for longitudinal adjust-
ment
Motor 400336 complete
V- belt 800170 10 x 710 mm
V- belt 800114 10 x 790 mm
V- belt 800197 10 x 890 mm
Switch 400343 complete unit with relay
Transmission/lock nut *)
Slide spindles, slide nuts *)
Ball- and roller bearings *)
Revolving center 330557 MT-2
Drill chuck 13 mm 330240 self-stretching, J2 connection
Drill chuck 16 mm 330250 self-stretching B-18 connection
Adaptor B-18/MT-2 330297 for drill chuck 16 mm
Chisels 10 x 10 mm 331466 5 parts HM, lenght 160 mm
Chisels 12 x 12 mm 331464 5 parts HM, 180 mm
Chisels 16 x 16 mm 331465 5 parts HM, 180 mm
Taper shank drills 332407 9 parts: MT-2: 14.5, 16, 18, 20
and 22 mm.
MT-3: 24, 26, 28, 30 mm.
Taper shank drills 332409 10 parts: MT-2: 14.5, 15, 16, 17,
18, 19, 20, 21, 22 and 23 mm
Morse taper 330180 from MT-4 to MT-3
Morse taper 330185 from MT-3 to MT-2
Morse taper 330190 from MT-4 to MT-2
*) These part are not always in stock. Ask your local Ferm-dealer.
41