Make Electrical Connection - Elica LI32WA Guide D'utilisation, D'entretien Et D'installation

2. Using 2 or more people, hang the range hood on the the wall
by placing the slotted holes in the range hood back over the 2
screws mounted to the wood support mounted to the wall.
NOTE: If your installation uses the optional duct cover, the vent sys-
tem needs to be connected to the hood and the duct cover mounted
to the top of the range hood before tightening the mounting screws.
C
21¼" (54cm)
A. Key hole slots
B. Security lower key holes (2 - 6 x 80 mm)
C. Security key holes (4 - 4.2 x 19 mm)
D. Knockouts
C
B
3. Adjust depth of original mounting screws in the wood support until
they protrude ⁄ " forward. This
1
4
hang the hood (A).
4. Push the range hood up into the narrow slots, align the bottom of
the hood to the horizontal line, level the hood, and tighten the 2
mounting screws.
5. Mark 2 lower mounting hole locations. Drill
holes are located into wood. If holes are not located into wood,
remove the hood and drill two
mm wall anchors. Remount the hood, level, and tighten the upper
screws. Install 2 - 6 x 80 mm screws and 2 - flat washers into the
lower mounting anchors and tighten (B).
6. Install 4 - 4.2 x 19 mm screws through the back of the hood
into the wood support and tighten (C).
7. Connect vent system to hood. Seal all joints with clamps.
8. If your installation uses the optional duct cover, mount it to
the top of the range hood following the instructions supplied
with the duct cover.
A C
B
Rear View
A
C
D
⁄ " gap will provide clearance to
1
4
⁄ " pilot holes if the
1
8
⁄ " pilot holes and insert 10 x 50
3
8

Make Electrical Connection

WARNING: Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Locate junction box inside of the range hood.
A. Knockout in canopy back into terminal box
A
B
C
D
A.White wires
B. Black wires
C. UL listed wire connectors
3. Use UL listed wire connectors and connect black wires (B)
together.
4. Use UL listed wire connectors and connect white wires (A)
together.
5. Connect green (or bare) ground wire from home power supply
to the green/yellow ground wire (D) in terminal box using UL
listed wire connectors.
6. Install terminal box cover.
7. Check that all light bulbs are secure in their sockets.
8. Reconnect power.
8
A
E
F
D. Green, Bare or Yellow/Green wires
E. Home power supply
F. UL listed or CSA approved ½" strain
relief