Scan Mode - Leica RANGEMASTER 2000-B Notice D'utilisation

SCAN MODE

61
72
The Leica Rangemaster 2000-B can also be used for continu-
ous measurements (scan mode):
Hold down the main button (2) at the 2
After around 2.5 seconds, the device switches to scan mode
and then carries out continuous measurements. This can be
seen by a change in the display. Around every 1 second, a
new measured value is shown.
65
Scan mode is particularly useful for measuring the range to
small or moving targets.
Notes:
• In scan mode, the ABC correction value (see p. 36) is only
displayed after the last measurement.
• Because of the continuous measurements, power con-
sumption is greater in scan mode than for single measure-
ments.
31
press.
nd