Electrical Connections - Fulgor Milano Sofia 30 Instructions D'installation

CAUTION
Do not repair or replace any part of the appliance unless
specifically recommended in the manual. All other servicing
should be done by a qualified technician. This may reduce
the risk of personal injury and damage to the appliance.
Never modify or alter the construction of the appliance by
removing panels, wire covers, screws, or any other part of
the product.
Factory Connected Power Supply Cord
Your range is equipped with a factory-connected power cord.
Cord must be connected to a grounded 120/240 volt or
120/208 volt range outlet. If no outlet is available, have one
installed by a qualified.
Only the 4-wire power supply cord with NEMA 14-50P plug
included with the product is considered part of the ETL certified
product. If the included cord is removed or replaced, the
alternate power connection solution will not be considered as
part of the certified product. Any damage or personal injury
resulting from an alternative power supply solution will not
be the responsibility of the manufacturer and may void the
warranty.
PLUG POWER SUPPLY CORD
NEMA 14-50P Plug
NEMA 10-50P Plug
(for US only)
Power Supply Cord Kit or Flexible Conduit (for US only)
The user is responsible for connecting the power supply cord to
the connection block located behind the back panel access cover.
This appliance may be connected by means of permanent
"hard wiring" (flexible armored or nonmetallic shielded
copper cable), or by means of a power supply cord kit. Use
only a power supply cord kit rated at 125/250 volts minimum
and marked for use with ranges. Cord must have either 3 or
4 conductors. Terminals on end of wires must either be closed
loop or open-end spade lugs with upturned ends.
For 30", 36" and 48" ranges use a power supply cord kit
rated at minimum 50A that is marked for use with nominal
1-3/8 in (34.93 mm) diameter connection openings.
1) Disconnect power.
2) Remove the terminal block cover screws located on the back
of the range.
NEMA 14-50R Receptacle
NEMA 10-50R Receptacle
(for US only)

8 - Electrical connections

LOCATION OF ELECTRICAL CONNECTION
3) Add strain relief if not provided.
NOTE: If necessary remove the knockout to insert the strain relief.
Power supply cord strain relief
• Assemble a UL listed strain relief in the opening.
UL LISTED STRAIN RELIEF
• Feed the power supply cord or flexible conduit through
the strain relief in the cord/conduit plate on bottom of
range. Allow enough slack to easily attach the wiring to the
terminal block.
• Tighten strain relief screw against the power supply cord or
flexible conduit.
POWER SUPPLY CORD
4) Complete installation following instructions for your type of
electrical connection:
• 4-wire (recommended)
• 3-wire (if 4-wire is not available)
EN
FLEXIBLE CONDUIT
21