Setup And Adjustments - TECO 320 Manuel D'instructions

• Grease sliding seats of blocks placed under platforms and on bases;
• Clean all parts of the machine;
• Connections as per diagrams;
• Lift grounding;
• Proper oil level in the tank;
• No leakage and blow-by;
• Cylinder operation.
Carry out two or three complete cycles of lowering and lifting and check:
• the lift for reaching its maximum height;
• the horn/signaling light for proper operation during the final travel (only recessed
version).
Repeat checks provided for by 7.11.1 section with the vehicle loaded.
After carrying out the checks with load, make a visual inspection of the machine and check
bolts and nuts for proper tightening.
58
7.10 Checks and inspections
7.10.1 Mechanical checks
7.10.2 Electrical checks
7.10.3 Hydraulic system check
7.11 Set up and adjustments
7.11.1 Load less check
WarNiNG: please follow carefully the instructions in the coming
paragraph for avoiding damages on the lift.
7.11.2 Check with load
7.11.3 Bolts and nuts check
EN - Operator's manual