General Warnings - TECO 320 Manuel D'instructions

The operator and the person in charge of maintenance must follow accident-prevention
laws and rules in force in the country where the lift is installed.
They also must carry out the following:
• neither remove nor disconnect hydraulic, electric or other safety devices; carefully follow
the safety indications applied on the machine and included in the manual;
• observe the safety area during lifting;
• be sure the motor of the vehicle is off, the gear engaged and the parking brake put on;
• be sure only authorized vehicles are lifted without exceeding the maximum lifting capacity;
• verify that no one is on the platforms during lifting or standing.
To avoid overloading and possible breaking, the following safety devices have been used:
• A maximum pressure valve placed inside the hydraulic unit to prevent excessive weight.
• A special design of the hydraulic system, in case of pipeline failure, to prevent sudden
lift lowering.
All risks the personnel could run, due to an improper use of the lift, are described in
this section.
During lowering of runways and vehicles, personnel must not be within the area cov-
ered by the lowering trajectory. The operator must be sure no one is in danger before
operating the lift.
When the lift is stopped at relatively low height for working,
the risk of bumping against projecting parts occurs.
52

6.1 General warnings

6.2 risks during vehicle lifting
6.3 risks for people
6.4 Personnel crushing risks
Fig. 9a
6.5 Bumping risk
Fig. 9b
Fig. 9c
Fig. 10
EN - Operator's manual