TECO 320 Manuel D'instructions page 53

6.6 risk of the vehicle falling from the lift
Vehicle falling from the lift can be caused when the vehicle is improperly placed on
platforms, and when its dimensions are incompatible with the lift or by excessive move-
ment of the vehicle.
In this case, keep immediately away from the working area.
Fig. 11a
Fig. 11b
Fig. 11c
6.7 Slipping risks
The risk of slipping can be caused by oil or dirt on the
floor near the lift.
Fig. 12
Keep the area under and around the lift clean. remove all oil spills.
6.8 Electrocution risks
Avoid use of water, steam, solvent, varnish jets in the lift area where electric cables are
placed and, in particular, next to the electric panel.
6.9 risks resulting from improper lighting
Make sure all areas next to the lift are well and uniformly lit, according to local regulations.
6.10 risks of breaking component during operation
Materials and procedures, suitable for the designed param-
eters of the lift, have been used by the manufacturer to build
a safe and reliable product. Operate the lift only for the use it
has been designed for and follow the maintenance schedule
shown in the chapter "Maintenance".
Fig. 13
EN - Operator's manual 53