Installation Precautions; Power Source; Accessory Parts - Haier AP24UFAHRA/1U24REAFRA Manuel D'utilisation Et D'installation

Installation Precautions

Caution
This manual describes the use of Qingdao Haier Air-conditioner Limited Company set up the
installation of tools for air conditioners to install the method.
1. In order to make the air conditioner work well, please the indoor machine and the outdoor machine is 10
install the air conditioner in accordance with the meters.
requirements of this manual.
5. To prevent turning over, please do not push, pull the
2. When moving the air conditioner, be careful not to indoor machine body..
scratch the surface of the casing.
6. After installation, please use the air conditioner
3. Please use the connecting pipe supplied by the correctly according to the instruction manual.
company to connect the indoor and outdoor machines.
7. Please keep the manual for use in repair or
4. The maximum length of the connecting pipe is 20 replacement of the installation location.
meters, and the maximum height difference between
Selection of pipe
Necessary Tools for Installation
Torque wrench
Driver
To this unit, both liquid and gas pipes shall be insulated
(17mm, 22mm,26mm)
Nipper
as they become Iow temperature in operation.
Hacksaw Pipe cutter
Use optional parts for piping set or pipes covered with
Hole core drill Flaring tool
equivalent insulation material.
Knife
Spanner(17,19 and 26mm)
Gas leakage detector or Measuring tape
soap-and-water solution Reamer
Selection of Installation Place
Before inserting power into receptacle, check the voltage
without fail.
The power supply is the same as the corresponding
Installation of indoor unit
nameplate. Install an exclusive branch circuit of the power.
Place where it is easy to route drainage pipe
A receptacle shall be set up in distance where the power
and outdoor piping. cable can be reached. Do not extend the cable by cutting it.
Place away from heat source and with less
direct sunlight.
Place where cool and warm air could be
delivered evently to every corner of the room.
Place near power supply socket. Leave enough
space around the unit.
No.
Place robust not causing vibration,where the
1
body can be supported sufficiently.
2
3
Installation of outdoor unit
4
selection of installation place 5
Place strong enough to support the unit and will
6
not cause vibration and noise.
7
Place where discharged wind and noise doesn't
8
cause a nuisance to the neighbors.
9
Place where is less affected by rain or direct sunlight
10
and is sufficiently ventilated,or to install a shield.
Place with enough space for smooth air flow.
11
12
24
6.35×0.53mm
12.7×0.8mm

Power Source

Accessory Parts

Shape QTY
Prevent fall parts 1
Dry battery 2
Drain Pipe 1
Bracket 4
Plain cushion 3
Screw set / nuts 1
W all hole cover 1
Remote controller
1
User manual
1
Wiring 4
Power switch 1
LIEP module 1