Cleaning The Hook-In Racks; Faults And Repairs - CONSTRUCTA CF232450 Mode D'emploi

Cleaning the door panels
To assist with cleaning, the inner door panel can be removed
from the appliance door.
ã=
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
ã=
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note: Before removing, make a note of the orientation in which
the door panel is fitted, so that it is not refitted the wrong way
round.
Unhook the appliance door and lay it on a soft, clean surface
1.
with the front side facing downwards (see section: Removing
and installing the appliance door).
Unscrew the cover at the top left and right of the appliance
2.
door and detach it (figure A).
Lift the door panel and remove it (figure B).
3.
$
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the door panel
Slide in the door panel all the way.
1.
Put the cover back in place and screw it in.
2.
Refit the appliance door.
3.

Faults and repairs

In the event of a fault, check the tips in the following table
before calling the after-sales service.
Problem
Electrical operation is malfunctioning (e.g.
indicator lamps do not light up)
Liquid or thin dough runs to one side
‹:‹‹ flashes in the clock display
60
%
Possible cause
Faulty fuse
Appliance not installed level
Electricity supply was cut

Cleaning the hook-in racks

You can remove the hook-in racks with telescopic shelves for
easier cleaning.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side (figure A).
Pull the hook-in rack forwards at the rear and unhook to the
2.
side (figure B).
$

Clean the hook-in rack with washing-up liquid and a sponge
3.
or brush.
Reattach the hook-in rack to the same side wall.
4.
Insert the hook-in rack at the rear to the limit stop.
5.
Push the hook-in rack towards the rear.
6.
Insert the hook-in rack at the front to the limit stop and push
7.
downwards.
Push telescopic shelves in as far as the stop and close
8.
appliance door.
ã=
Risk of electric shock!
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Remedial action
Check fuses in the fuse box and replace if
necessary
Check the appliance installation (see the
Installation instructions)
Reset the clock (see section: Electronic
clock)
%