Problems , Causes And Solutions; Declaration Of Compliance - GYS FLASH 7A Manuel D'utilisation

It is autoprotected to stop charging (+
1V±0.5V).
The GYSFLASH has a thermal sensor, and if the machine becomes too hot during the charge cycle, it
will automatically reduce the power of charge. When the temperature is acceptable, the GYSFLASH
will come back to its normal charging power.
,
PROBLEMS CAUSES AND SOLUTIONS
In case of problem, the charger automatically switches on protection mode and the power
indicator illuminates. The system will remain in that position until the user intervenes.
Problem
Power Indicator
Illuminates
Indicator is on
and is flashing
Both indicators are
on
D
ECLARATION OF COMPLIANCE
GYS certifies that the product described on this manual is manufactured in compliance with the requirements
of the following European directives:
- Low Voltage Directive: 2006/95/CE - 12/12/2006
- EMC Directive: 2004/108/CE, 15/12/2004,
It therefore complies with the following harmonized standards: EN60335-1 - EN60335-2-29 – EN55014-1 -
EN55014-2 – EN61000-3-2– EN61000-3-3 – EN62233.
will be displayed) if the voltage of the battery drops below
Causes
 Short circuit
 Circuit open
 Battery voltage
< 1V ± 0.5 (for a 12V battery)
Polarity reversal
Wrong battery voltage
The unit has detected a battery
that can't be recovered.
Thermal fault
XX XXX
Solutions
1- Check that there is no voltage loss
in the vehicle circuit
2- Check that the clamps are well
connected
3- After corrections,
indicator is still on, the sulphated
or damaged battery
replaced (nb: are you in 12V or 13.6V
mode maximum?
recovery function)
Check that the clamps are correctly
connected
24V battery connected
Change the battery.
The temperature is too high, ventilate
the area.
XXX
if the
should be
Please try the
9/33