Care And Maintenance; Maintenance Table - Hilti DSH 700 Mode D'emploi Original

Reasons for the cutting disc stalling:
• The cut is too deep.
• The kerf closes (e.g. when cutting pipes or slabs).
• The cutting disc is off-square in the kerf.
• The cutting disc is unsuitable for the job (the cutting disc becomes clogged).
• The cutting disc is inserted too quickly into an existing kerf.
The hazardous situations that result from stalling differ, depending on the working position.
• Forward pull can occur when a horizontal cut is being made (e.g. in the ground). The saw suddenly
snatches forward, possibly pulling out of your hands.
• Climbing can occur when a vertical cut is being made (e.g. in a wall). The saw suddenly snatches upward,
possibly pulling out of your hands.
• Kickback can occur if the prohibited area of the disc is brought into contact with the workpiece.
To avoid the hazardous situations that result from stalling of the cutting disc:
▶ When cutting a thick workpiece, increase the depth of the kerf in steps. Avoid excessively deep cuts.
▶ Support slabs or large workpieces so that the kerf remains open during and after the cutting operation.
▶ Always bring the cutting disc into contact with the workpiece from above.
◁ Allow the cutting disc to contact the workpiece only at a point below the rotational axis of the disc.
▶ Take great care when guiding the cutting disc into an existing kerf.
▶ Do not tilt the cutting disc in the kerf.
7

Care and maintenance

WARNING
Risk of injury. Touching the rotating cutting disc or hot parts of the machine may lead to injury or burns.
▶ Switch the engine off and allow the product to cool down before all maintenance, repairs, cleaning or
servicing.
7.1

Maintenance table

Check that the tool is complete, in perfect condition
and free of leaks. Have it repaired if necessary.
Check for dirt and foreign matter. Clean if necessary.
Check that the controls function correctly. Have repairs
carried out if necessary.
Check that the cutting disc is in perfect condition.
Replace if necessary.
Check that all externally accessible nuts and screws are
securely tightened.
Check that the fuel filter is clean. Replace it if neces-
sary.
Replace the air filter if the product does not start or
engine performance fades noticeably.
Clean or replace the spark plug if the product does not
start or is difficult to start.
Adjust the idling speed if the cutting disc does not slow
to a standstill when the engine is idling.
Have the product repaired by Hilti Service if the drive
belt slips when a load is applied to the cutting disc.
2122989
*2122989*
Printed: 17.05.2018 | Doc-Nr: PUB / 5252090 / 000 / 07
Before use Every 6
months
X
X
X
X
X X
X
If necessary
X
X
X
X
X
X
English 15