Hilti DSH 700 Mode D'emploi Original page 21

WARNING
Risk of injury. A damaged exhaust system will raise the noise level above the permissible limit and thus
cause hearing damage.
▶ Never use the product if the exhaust system is damaged, missing or if it has been tampered with.
CAUTION
Risk of burns or injury through pinching the fingers when the water pump is fitted. Touching the pump
housing can cause burning injuries.
▶ Hold the forward grip only at the top and on the left side.
1. If the following equipment exists, also take this action:
DSH 700
DSH 900
▶ Press the decompression valve (once).
▶ Squeeze the primer bulb 2 to 3 times until the primer bulb is completely filled with fuel.
▶ Move the start/stop switch to the "start" position.
▶ If the following conditions are met, also take this action:
Conditions: The engine is cold.
▶ Pull the choke lever upwards.
◁ The choke and half throttle are engaged.
▶ If the following conditions are met, also take this action:
Conditions: The engine is hot.
▶ Pull the choke lever upwards and then push it back down again.
◁ This engages half throttle. The choke is not engaged.
▶ Check that the cutting disc is free to rotate.
▶ Position your right foot over the lower part of the rear grip.
▶ Pull the starter handle slowly with your right hand until resistance is felt.
▶ Pull the starter handle vigorously.
▶ When the motor fires for the first time (after 2 to 5 pulls of the starter), move the choke lever back
down to its original position.
▶ Pull the starter handle vigorously and repeat this action until the engine starts.
The motor will flood if the starting procedure is repeated too many times with the choke
engaged.
▶ Press the throttle trigger briefly as soon as the engine starts.
◁ This disengages the half-throttle position and the engine then runs at idling speed when the
throttle is released.
2. If the following equipment exists, also take this action:
DSH 700-X
DSH 900-X
▶ Press the decompression valve (once).
▶ When starting the cold engine (only when cold), squeeze the primer bulb 2 to 3 times (until the primer
bulb is completely filled with fuel).
▶ Press the throttle safety grip and keep it pressed.
▶ Press the throttle trigger and keep it pressed.
▶ Move the start/stop switch to the "start" position.
▶ Release the throttle safety grip and throttle trigger.
◁ This half-throttle position is activated.
▶ Check that the cutting disc is free to rotate.
▶ Position your right foot over the lower part of the rear grip.
▶ Pull the starter handle slowly with your right hand until resistance is felt.
▶ Pull the starter handle vigorously.
▶ Repeat this action until the engine starts.
▶ Press the throttle trigger briefly as soon as the engine starts.
◁ This disengages the half-throttle position and the engine then runs at idling speed when the
throttle is released.
2122989
*2122989*
Printed: 17.05.2018 | Doc-Nr: PUB / 5252090 / 000 / 07
English 13