Hilti DSH 700 Mode D'emploi Original page 22

6.2 Checks after starting the engine
1. Check that the cutting disc remains stationary when the engine is idling and, after briefly running at full
speed, that the disc again comes to a complete standstill.
◁ Readjust (reduce) the idling speed if the cutting disc doesn't stop rotating when the engine is idling.
If this is not possible, please bring the product to Hilti Service.
2. Check that the start/stop switch is functioning correctly. Move the start/stop switch to the "stop" position.
3. If the following equipment exists, also take this action:
DSH 700
DSH 900
▶ If the engine doesn't stop, push the choke lever upwards. If the engine still doesn't stop, pull the
spark plug connector off the spark plug and bring the product to Hilti Service.
4. If the following equipment exists, also take this action:
DSH 700-X
DSH 900-X
▶ If the engine doesn't stop, compress the primer bulb. If the engine still doesn't stop, pull the spark
plug connector off the spark plug and bring the product to Hilti Service.
6.3 Switching the engine off
WARNING
Risk of injury. A rotating cutting disc can break or shatter, possibly resulting in flying fragments.
▶ Allow the rotating cutting disc to come to a complete standstill before you lay the saw down.
1. Release the throttle trigger.
2. Move the start/stop switch to the "stop" position.
◁ The engine stops.
6.4 Cutting techniques 9,
WARNING!
In order to work optimally with this tool, comply with the following safety instructions:
▶ Always hold the product and the saw trolley firmly with both hands on the grips provided. Keep the grips
dry, clean and free from oil and grease.
▶ Before starting work, and immediately after unforeseen contact is made with an obstacle, make sure that
the cutting disc and the guard are undamaged.
▶ Make sure there is no-one in the working area and, in particular, in the direction in which the cut is to be
made. Keep everyone approx. 15 m away from your workplace.
▶ Guide the product smoothly and do not apply lateral pressure to the cutting disc.
▶ Avoid dangerous operating positions.
▶ Always bring the cutting disc into contact with the workpiece at right angles. Do not attempt to change
the line of cut by applying lateral pressure or by bending the cutting disc while cutting is in progress.
▶ Secure the workpiece. Use clamps or a bench vise to hold the workpiece in position. The workpiece is
thus held more securely than by hand and both hands remain free to operate the product.
▶ Clamp round workpieces so that they cannot turn.
▶ Do not attempt to cut two or more workpieces at the same time. Cut them one after the other.
▶ Secure both the workpiece and the off-cut to prevent uncontrolled movement.
▶ When working with the saw trolley, check before use that the gasoline-powered saw is mounted correctly
on the saw trolley.
▶ Switch the gasoline-powered saw off immediately at the ON/STOP switch if the saw trolley throttle cable
sticks or if the throttle trigger sticks.
▶ Always use full throttle when cutting.
Prevent the cutting disc from stalling
WARNING
Risk of bruising or other injuries. Sticking / stalling of the cutting disc in the kerf may cause the saw to be
pulled forward, to climb or cause kickback.
▶ Take care to avoid sticking / stalling of the cutting disc while cutting.
14 English
Printed: 17.05.2018 | Doc-Nr: PUB / 5252090 / 000 / 07
10
2122989
*2122989*