Installation Location; Connecting The Appliance; Electrical Connection; Getting To Know Your Appliance - Bosch KUR Série Mode D'emploi

en

Installation location

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e. g. a
cooker, radiator, etc. If installation next to
a heat source is unavoidable, use a
suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
■
Undercounter
An attachment under certain worktops,
e.g. stone, glass or stainless steel, is
frequently not possible. You can order
accessories from customer service for
installation on the side walls.
Connecting the
appliance
After installing the appliance, wait at least
1 hour until the appliance is switched on.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter "Cleaning the
appliance").
18

Electrical connection

The socket must be near the appliance
and also freely accessible following
installation of the appliance.
The appliance complies with the protec-
tion class I. Connect the appliance to
220–240 V/50 Hz alternating current via
a correctly installed socket with protec-
tive conductor. The socket must be fused
with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the
stated voltage and current type match
the values of your mains supply. This
information can be found on the rating
plate. Fig. -
Getting to know your
appliance
Please fold out the illustrated last page.
These operating instructions refer to
several models.
The features of the models may vary.
The diagrams may differ.