ResMed Mirage Swift II Mode D'emploi page 9

Daily
Handwash the pillow sleeve assembly, short tube assembly and cap in warm
(approx. 86°F/30°C) water using mild soap or detergent. Rinse the components
well and allow them to air dry out of direct sunlight and heat.
The system components have been tested using Dove
Note: Ensure that the vent holes are not blocked. Use a soft bristle brush to
clean the vent.
Weekly
Handwash the headgear, tube retainer and all components in warm,
(approx. 86°F/30°C) water using mild soap or detergent. Rinse the components
well and allow them to air dry out of direct sunlight and heat.
CAUTION
.
•
Do not use solutions containing bleach, chlorine, alcohol, aromatics,
moisturizers, antibacterial agents, or scented oils to clean any part of
the system or air tubing. These solutions may cause damage and
reduce the life of the product.
•
Exposing any part of the system or tubing to direct sunlight or heat
may cause deterioration.
•
If any change in performance or visible deterioration of a component is
apparent (cracking, crazing, tears etc), the component should be
discarded and replaced.
Reprocessing the Mirage Swift II between
Patients
Only Sleep Lab Mask (SLM) variants of the mask are intended for
multi-patient re-use. When using between patients, these masks must be
reprocessed according to cleaning and disinfection instructions available on
ResMed.com/downloads/masks.
Reassembling the Mirage Swift II
CAUTION
Components of the Mirage Swift II pillow sleeve assembly (pillow sleeve,
frame and clip—see section A on the illustration sheet) are not compatible
for use with Mirage Swift components. Combining these components
from the two systems may result in rebreathing of exhaled air.
Unscented beauty bar.
™
5