Initial Start-Up; Preparation For Use - Dräger Alcotest 5000 Notice D'utilisation

4.1.3

Initial start-up

A setup wizard is opened when the instrument is switched on for the
first time.
The following settings are made using the setup wizard:
Language

Date

Time format

Time

All settings can be changed later on via menu.
NOTICE
Loss of pre settings. If the batteries are removed longer than
5 minutes, the date and time have to be set again.
4.2

Preparation for use

1. Make sure the batteries are charged and inserted.
2. Make sure a clean funnel is attached.
3. Make sure the instrument is held tightly and safely by using the
wrist strap or telescope bar properly.
4. Switch on the instrument by pressing OK (see page 14 section
"Switching the instrument on and off").
If the instrument is ready for measurement, an empty bar is shown

in the display.
Intended use
en
10