Error Messages With Unique Allocation - SICK LCU-P Guide D'utilisation

Operating instructions
LCU-P
10.2
Code Fault Message
1 6 INVALID MODE CHANGE
PRESS ESCAPE KEY
18 CONFIG. FAULT: 18
PRESS ESCAPE KEY
19 CONFIG. FAULT: 19
PRESS ESCAPE KEY
20 CON FIG. FAULT: 20
PRESS ESCAPE KEY
21 CONFIG. FAULT: 21
PRESS ESCAPE KEY
22 CON FIG. FAULT: 22
PRESS ESCAPE KEY
23 CON FIG. FAULT: 23
PRESS ESCAPE KEY
24 CON FIG. FAULT: 24
PRESS ESCAPE KEY
2 5 CONFIG. FAU LT: 25
PRESS ESCAPE KEY
26 CON FIG. FAULT: 26
PRESS ESCAPE KEY
27 CON FIG. FAULT: 27
PRESS ESCAPE KEY
28 CON FIG. FAULT: 28
PRESS ESCAPE KEY
29 CON FIG. FAU LT: 29
PRESS ESCAPE KEY
30 CON FIG. FAULT: 30
PRESS ESCAPE KEY
31 CONFIG. FAULT: 31
PRESS ESCAPE KEY
32 CON FIG. FAULT: 32
PRESS ESCAPE KEY
33 CON FIG. FAULT: 33
PRESS ESCAPE KEY
34 CON FIG. FAULT: 34
PRESS ESCAPE KEY
35 CON FIG. FAU LT: 35
PRESS ESCAPE KEY
8 008 364/NB 86/25-04-00 © SICK AG • Safety Systems • Germany • All rights reserved
Diagnostic Messages

Error messages with unique allocation

Fault Description
Invalid mode change by the rotary switch.
No Country code was entered for the desired
operating mode.
Two muting pairs and single stroke restart are
selected.
Blanking attempted with a TYPE 2 Primary.
Reduced resolution with a TYPE 2 Primary.
Floating blanking is enabled without the American
Code entered.
More than 16 beams indicated for floating blanking.
Floating blanking was selected with PSDI.
Attempted to execute reduced resolution with
a 30 mm AOPD.
External Restart and Restart Interlock for
Secondary AOPD selected.
Single stroke Restart selected with PSDI.
Invalid reduced resolution mode for American
code entered with guard only.
Invalid reduced resolution mode for American
code entered with PSDI.
Invalid reduced resolution mode for European
code entered with guard only.
Invalid reduced resolution mode for European
code entered with PSDI.
One safety channel sent setup information of size 0.
One safety channel sent configuration information
of size 0.
Swedish Restart selected with external restart.
LCU-P programmed for PSDI mode with a PSDI timer
and external restart is selected.
GB
Chapter 10
353