Section 5. User Set Up Options; Setting Time-Of-Day; Labeling Speeds; General Labels - Zodiac JEP-R Mode D'emploi

Page 16
ENGLISH
To enable the power display feature, from the service setup
menu select DISPlaY POwER USaGE. Press MEnU to
select. Using the arrow keys, select YES. Press MEnU to
accept and store.
To disable the power display feature, from the service setup
menu select DISPlaY POwER USaGE. Press MEnU
to select. Using the arrow keys, select nO. Press MEnU to
accept and store.

Section 5. User Set Up Options

nOTE The controller must be in the
entering the user setup mode. While in setup mode
the controller will return back to the
one (1) minute since the last key press.
When in setup mode, speed keys "
as 'escape' or exit keys while navigating the setup menu.
To enter the setup mode, press and hold the MEnU button
for five (5) seconds. The controller displays SElECT USER
SETUP. Using the arrow keys, select the desired setup item
to change.
5.1

Setting Time-of-Day

From the Setup menu, select SET TIME. Press the MEnU
button to display the currently-set time. Using the arrow keys,
adjust to the desired time. Press MEnU to save your setting.
5.2

labeling Speeds

The controller comes from the factory with pre-programmed
labels or names for the preset speeds. The labels may be
changed as desired to suit your particular installation.
Two (2) types of labels are provided by the controller:
• General Labels - selected from a list
• Custom Labels - created by the user
ePump™ and VS-FloPro™ Variable-Speed Pump Controller
OFF
mode before
OFF
mode after

" through "4" are used
From the setup menu, scroll to labEl SPEED and press
MEnU. The SElECT SPEED screen is displayed. Press the
MEnU button to display the currently selected speed. Using
the arrow keys, choose the speed to be changed. Press MEnU
to select. The controller displays SElECT labEl TYPE.
Select GEnERal or CUSTOM as desired using the arrow
keys.
SELECT USER SETUP
LABEL SPEED
5.3

General labels

Using the arrow keys, select a general label from the list to
assign to the speed. Press MEnU to assign the label to the
speed.
LABEL SPEED
FILTRATION
5.4

Custom labels

In the custom label mode, the controller displays a flashing
cursor at the character position to be changed. Using the
arrow keys, change the character as desired. Press MEnU to
accept the change and advance to the next character position.

Press any speed key " " through "4" to return to the
previous cursor position.
LABEL SPEED
1:PRESET 1
Continue this procedure until the end of the label is reached.
The new label is saved when MEnU is pressed at the last
character position.
|
Installation Manual