VWR SAS Super ISO Manuel D'instructions page 25

Change the figure indicated by "^" by pressing the "UP" or "DOWN" arrows and press ENTER to go to the next
figure.
Repeat until you reach the last figure and then confirm by pressing ENTER; you can now choose to programme the
SAS in single mode or multi mode.
Select the desired interval time between sampling by pressing the "UP" or "DOWN" arrows. Press ENTER to go to
the next digit.
The interval time can be set from 0 to 59 minutes.
Note: If you want to programme a single cycle set INTERVAL TIME to 0 minutes
Press ENTER to confirm.
Select the desired numbers of sampling cycles by pressing the "UP" or "DOWN" arrows.
Press the ENTER button to go to the next digit.
The maximum numbers of cycle is 19.
Note: If you want to programme a single cycle set NUMBER OF RUNS to 1.
IDENTIFY
[ 12345678]
^
CLEAR
IDENTIFY
[ 35345678]
^
CLEAR
INTERVAL TIME
[ 00 ] Minutes
^
CLEAR
NUMBER OF RUNS
[ 01] RUN
^
CLEAR
ENTER
ENTER
ENTER
ENTER
25