Fan / Blower - Regency Classic I1205M Manuel D'installation Et D'utilisation

installation
16 |
Installer: Please record unit serial number here before installing blower.
Serial No.______________________________

FAN / BLOWER

Your fan should only be installed once the unit
is in place in order to prevent any damage to
the fan.
1) Align the fan support with the offset clip on
the bottom of the ashlip.
2) Slide the supports into the clips. The tension
holding the clips in place may be adjusted by
increasing or decreasing the offset spacing
of the clips.
3) Ensure that the power cord is not in contact
120V AC
60 Hz
Fan Thermodisc
(normally open)
16 | I1205
with any hot stove surfaces.
Do not turn fan ON until your insert has
reached operating temperature or at least
30 minutes after starting fire.
CAUTION: Label all wires prior
to disconnection when servic-
ing controls. Wiring errors can
cause improper and dangerous
operation.
Neutral
Green
Live
Ground
Manual/
Auto
Switch
Black
Black
Blower / Fan Wiring Diagram
WARNING:
Electrical Grounding Instructions
This appliance is equipped with a
three pronged (grounding) plug for
your protection against shock hazard
and should be plugged directly into
a properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this plug.
Grounding
Lug Detail
Lockwasher
Star washer
Star washer
Wire98gr.eps
updated Jan. 27/00
updated: Aug. 09/05
capitalized the word Nut
Fan
Switch
Black
Fan Fan
#8 Groun Lug d
Ground wire
Nut
from fan
Nut
Ground wire
from power cord
Ground