Fan Installation - Regency Classic I1205M Manuel D'installation Et D'utilisation

installation
14 |
Regular/Oversize Faceplate Trim Installation:
(Black Trim included with Regular/Oversize Faceplate
or Bottom Faceplate)
8) Assemble the left and right side trim to the top trim using the trim clips
provided as shown in Diagram 5.
NOTE: When using the optional bottom faceplate kit (part #171-928
for Regular or 171-930 for Oversize), the kit contains 2 long right/left
black trims. These will need to be cut to size depending on the over-
all height of the faceplate prior to assembling the trims. Use a hack
saw with a fi ne blade or cut off saw to cut the ends of the black trim.
The right/left black trim that were supplied with the regular/oversize
faceplate can be recycled as it is not required.
9) Fit the trim assembly over the faceplate assembly. See Diagram 6.
10) Drill two 5/32" diameter holes through the trim and side panels and
screw the trim to the panels using the self tapping screws provided
as shown in Diagram 6.
Shown with Optional Bottom Faceplate
14 | I1205
918-676d
Diagram 5
Diagram 6:
11) Mount the completed faceplate / trim assembly to the insert. Ensure
to align the side faceplate slots with the hex bolts in the mounting
brackets and tighten to secure in place.

Fan Installation:

12) Install the fan assembly to ash lip of insert as shown in Diagram 7.
a) Align the fan with the off set clips on the bottom of the ashlip.
b) Slide the supports into the clips. The tension holding the clips
in place may be adjusted by increasing or decreasing the off set
spacing of the clips.
c) Ensure that the power cord is not in contact with any hot stove
surfaces.
Optional Fan Support / Bottom Faceplate Installation:
13) To install the optional fan support, measure the distance between
the hearth and the bottom surface of the fan housing as shown in
Diagram 8.
Fan
Housing
Distance to Measure
Hearth
Diagram 8: Side View
3
I1200
Diagram 7
09/02/16