Burner And Orifice; Leak Check - Coleman RoadTrip 9949 Série Notice D'emploi

Attach Propane Cylinder
■ Before attaching propane
cylinder make sure burner
valves are in the OFF
position. (Fig. 13)
■ Remove plastic cap from top
of propane cylinder and
screw cylinder into regulator
hand tight. (Fig. 14)
■ Lift up on cylinder support on
back of stove and swing out.
(Fig. 15)
■ Screw regulator into stove
hand tight. (Fig. 16)
■ Place cylinder into cylinder
support. (Fig. 17)
Fig. 16
■ Never operate stove with
propane cylinder in an
inverted position.
(Fig. 18)
■ To open lid,
move lever to
OPEN position
and lift up.
(Fig. 19)
Fig. 19
■ Place a grill, griddle, or stove ring over
each burner. (Fig. 20, 21, and 22)
Fig. 20
Fig. 21
Fig. 13
Fig. 14
Fig. 15
Fig. 17
Fig. 18
English-5
Fig. 22
WARNING
DO NOT operate the stove with side tables in
storage position. Damage will occur and void
the warranty.
■ To extend side tables, grasp hold of side tables
on bottom of stove and slide out until fully
extended. (Fig. 23)
Fig. 23

Burner and Orifice

■ Proper location of the burner with respect to the
orifice is important. To verify the proper installa-
tion of the burner tube, use a screwdriver to
remove the stove top. The burner tube must be
located over the orifice fitting.
See Fig. 24 (stove top not shown).
Orifice Fitting
Fig. 24
■ Check and clean the burner/venturi tubes for
insects and insect nests. A clogged tube can
lead to a fire beneath the appliance.

Leak Check

WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor stove until connection
has been leak tested and does not leak.
Burner