Leak Check; Burner And Orifice - Coleman 9944 Serie Notice D'emploi

To Set Up
cont.
■ Place the grill onto the
stove.

Burner and Orifice

■ Proper location of the burner with respect to the orifice is important.
To verify the proper installation of the burner tube, remove the water
pan and look downward through the opening. The burner tube must
be located over the brass orifice fitting.
■ Check and clean the
burner/venturi tubes for
insects and insect nests. A
clogged tube can lead to a fire
beneath the appliance.

Leak Check

WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor stove until connection has been leak test-
ed and does not leak.
NOTE: Use Coleman® 16.4 oz disposable propane cylinders. The LP
gas cylinder(s) used with stoves must be constructed and marked in
accordance with the specifications for LP-gas cylinders of the U.S.
Department of Transportation or Transport Canada , CAN/CSA B339,
Cylinders, Spheres and Tubes for the Transportation of Dangerous
Goods.
Burner Tube
Brass
Orifice
Fitting
Leak Check
cont.
Step 1
■ Make sure burner valve is
off.
Step 2
■ Remove plastic cap from
top of propane cylinder. Save
cap for use in storing. Screw
propane cylinder into REGU-
LATOR. Be careful not to
cross-thread. HAND TIGHTEN
only.
Step 3
■ Check the connection
between the cylinder and
the regulator with soapy
water. Bubbles indicate a
leak. Check that the con-
nection is not cross-thread-
ed and that it is tight.
Perform another leak check.
If there is still a leak,
remove the cylinder and
contact Coleman for service
or repairs.
■ The regulator uses a
threaded fitting to attach
to the stove. It is neces-
sary to hold the stove to
make sure the fitting is
seated. Align the regula-
tor to the fuel tube on
the rear of the stove and
push on. Screw on the
outer threaded sleeve
in a clockwise direction
until tight.
Step 4
■ Never operate stove with
propane cylinder in an invert-
ed position.
Leak
Check
5