Elimination - Kopp NFRAcontrol R 180 UP Mode D'emploi

Incandescent lamp:
Halogen lamp:
Fluorescent lamp:
Low-voltage halogen lamp load:
D
Energy-saving lamps:
LED lamps:
Optional RC component (2915.0004.3): 100 nF / 100 Ω. Parallel connected to the inducted load.
Dimensions:
GB
Operating temperature:
Degree of protection:
NL
Several factors can affect the correct function of a motion sensor.
In the following, the most common faults, their causes, and elimination will be briefly explained.
F
Fault
Sensor does not switch on
I
Sensor does not switch off
P
No acoustic notification
26
max. 2000 W
max. 1200 W
max. 900 VA / 100 μF / (series compensated)
1000 VA
max. 600 VA
max. 500 VA
(50x50x65) mm
0 °C --> +45 °C
IP 40
Cause
Fuse defective
Sliding switch on OFF
Time setting is too long.
Motion sensor constantly triggers.
Incorrectly connected
„Acoustic" switch is on OFF

Elimination

Find and eliminate cause.
Replace fuse
Set sliding switch to AUTO or ON
Perform test mode
Check connection
Switch to ON mode