Shut Down - DeVilbiss Healthcare DV55 Bilevel Série Mode D'emploi

EN
NOTe– When the delay comfort feature is activated, a message will flash on the display
periodically, indicating the amount of time remaining in the delay.
You can adjust the amount of time spent in comfort delay by using
the advanced device controls. The Delay Time can be adjusted
from 0 to 45 minutes in 5-minute increments. Refer to page 14 for
details.
NOTe– If you are unable to change the delay time, your provider has locked this setting. Refer
to the keypad menu guide on page 13 for details.
Comfort Delay Feature In Standard CPAP Mode
When you use the comfort delay feature while your device is operating in CPAP mode, the
airflow you receive at the beginning of your therapy is temporarily lowered to a pressure
selected by your physician when the device was setup.
Press the delay button to activate the comfort delay feature. The airflow pressure will drop to
the prescribed comfort delay pressure.
The pressure will gently rise to the pressure prescribed for your therapy. You may repeat
the comfort delay by pressing the delay button again if you have not fallen asleep during the
first use.
Comfort Delay Feature in Bilevel Mode
When you use the comfort delay feature while your SleepCube is operating in Bilevel mode,
the airflow you receive at the beginning of your therapy is the delay pressure prescribed by
your physician when the device was setup. The airflow pressure will start at the delay
pressure and gradually rise to the prescription setting. In Bilevel mode, the IPAP and EPAP
pressures will gradually rise until they reach the prescription settings.

Shut Down

Press the ON/OFF button to turn the device off. You may also simply remove your mask.
After a few seconds the device will display the message "Mask Off. Please check mask fit." If
you do not put the mask on again the device will automatically turn off in about 20 seconds.
Pressing any button will remove the message from the display.
NOTe– If the DeVilbiss SleepCube does not turn off automatically, the "Auot-OFF" feature may
have been disabled. In this case you must manually turn the device off.
SE-DV56
12
opEration
Delay Running
10 Minutes Left