Machine Installation; Application Technique; Beginning Work - diversey TASKI ergodisc 2000 Mode D'emploi

Machine installation

Attaching tools
Check:
• the pad for wear and foreign bodies (e.g. grains of sans) before use.
• that the tool is correctly mounted.
Could cause damage to floor surface by negligence!
• Bring the machine into the pad-change position.
• In order to remove the pad fixation, you must
turn it to the right.
• Place the pad (1) centred on the pad drive and
secure it with the pad fixation (2).
1
2
Insert the disposble dust bag
Caution:
Never use the machine without a dust bag fitted.
• Remove the cover of the dust bag
compartment.
• Insert the dust bag with the opening (1)
on the suction tube (2).
2
In doing this,ensure that it jumps over the
1
locking element (the bulge).
• Close off the dust bag compartment again with
the cover.
Insert the suction hose
Check that the suction hose is correctly installed.
• The correct fitting of the suction hose prevents
dust from escaping.

Application technique

Machine
type
Wet cleaning & prime cleaning
Spray cleaning
Shampoo wet
Shampoo dry
Polish
Grinding
Crystallize

Beginning work

Caution:
It is recommended that inexperienced users should first practice
polishing a test surface until they have mastered the handling of
the machine.
Incorrect operation can damage the floor.
The pad rotates at 2,000 rpm. Only use approved tools.
• Connect the power supply cord to the mains socket.
• Switch the machine on by pressing the main
(ON/OFF) switch.
• Unlatch the foot lever and slowly lower the pad.
Lead the power supply cord with your hand.
Make sure that the power supply cord does not touch the tool.
Hold on to the machine.
• Bring the machine to the working position by
pressing the height adjustment lever on the
machine handle, and slowly lower the central
steel pillar until a comfortable working position
is achieved.
• Push the safety switch and press the operating
levers at the same time.
By doing this the machine is activated.
Setting the pads in motion starts the suction on the floor.
Caution:
The machine must not remain stationary while the engine is
running. This could damage the floor.
2000
2000HSP
no
no
no
no
yes
no
no
11