Belkin OmniView PRO Guide De L'utilisateur page 21

P73055/F1D108-OSD/EU/man.qxd
• Check your computer/motherboard documentation making sure that the serial ports
are enabled, and that there are no IRQ or base address conflicts with other serial ports
or modems.
• Plug in a serial mouse directly to your computer, and reboot. If the mouse pointer still
does not move, then there may be no serial mouse drivers installed, or the serial port
on your computer may have other conflicts or problems.
• Try a different PS/2 mouse at the console.
• Make sure the mouse (at the console) is a true PS/2 mouse. A combo mouse will work
just as long as it is set for PS/2 mode with the correct adapter. A serial-only mouse
with a combo mouse adapter WILL NOT work.
• Check to make sure that the power adapter is plugged in and is working properly.
It must be 12VDC, 1000mA minimum. Make sure the power switch is on.
• RESET the OmniView
CHANNEL buttons on the front panel. Access the OSD menu again and it should have
re-detected all the active ports.
Q: When I switch from one port to another, mouse movement is completely erratic.
What do I do?
A: • RESET the OmniView
CHANNEL buttons on the front panel. Access the OSD menu again and it should have
re-detected all the active ports.
• Make sure you do not have more than one serial mouse driver loaded. Make sure that
the driver is either for a Standard Serial or Microsoft
• Avoid using a specialized mouse at the console such as a cordless mouse, scrolling
mouse or mice with more than 2 operational buttons. Non-standard mice often use
non-PS/2 proprietary mouse protocol.
• Make sure you do not have any other mouse drivers loaded in your config.sys or
autoexec.bat files.
• Avoid moving the mouse or pressing the mouse buttons when switching ports.
• Reset the mouse to resume proper mouse movement simply by unplugging the mouse
from the OmniView
Q: The wheel on the IntelliMouse
A: • The Integrated Mouse Conversion Technology converts only the standard PS/2 signals
which are the buttons and the x and y coordinate movement, but not the wheel
movement or wheel button. This is because the wheel and wheel button data use
non-PS/2 protocol.
Notea bout the Optional Serial Mouse port at the console: If you have tried all possible
troubleshooting methods, you can plug in a serial mouse (as a second mouse) at the
optional serial mouse input port. See the Product Detail Section for the diagram. This mouse
will be directly connected to the serial mouse ports on the OmniView
serial mouse signals will not be converted to PS/2 mouse signals, so if you have other PCs
using PS/2 mouse ports, you must keep the PS/2 mouse at the console. This serial mouse is
a second mouse, and is active only when on a computer that uses the serial mouse output.
4/21/00 2:25 PM Page 17
Troubleshooting
PRO by simultaneously pressing the BANK/SCAN and
™
™ PRO by simultaneously pressing the BANK/SCAN and
™ PRO for about 2-3 seconds, and plugging it in again.
does not work on my computer. Why?
®
(continued)
® -compatible serial mouse.
™
17
PRO. Note that the
En